Table of Contents
Advertisement
Quantum DX-Series System Unpacking and Installation Instructions
Document 6513502-06 A01
October 2006
0
Cabling a DX30
Table 6 DX30 Fibre
Channel and Ethernet
Cabling
44
To cable a DX30 with up to four storage arrays:
1 Connect the power cords, LC-to-LC Fibre Channel cables, and Ethernet
network connection as shown in
Controller Connections (see
FC port 1
FC port 2
FC port 3
FC port 4
FC port 5
FC port 6
Eth0
Eth1
An additional Fibre Channel cable can be connected to port 6
Note:
on the dual port Fibre Channel HBA to support multiple
customer hosts or to improve throughput capability.
The medium changer (robot) and three virtual tape drives, by
Note:
default, are presented on port 5 and the remaining three
virtual tape drives are presented on port 6. Refer to
Configuring the Fibre Channel Settings
description of how to re-map the devices to Fibre Channel
ports.
Cabling the DX-Series System
table 6
and
figure
43.
figure
43)
Storage Array/Network
Storage array 1, FC-CH0 (right-
hand port)
Storage array 2, FC-CH0 (right-
hand port)
Storage array 3, FC-CH0 (right-
hand port)
Storage array 4, FC-CH0 (right-
hand port)
Customer FC host
Additional FC host
Customer network
Not used
on page 75 for a
Advertisement
Table of Contents
