Table of Contents
Advertisement
Quantum DX-Series System Unpacking and Installation Instructions
Document 6513502-06 A01
October 2006
Accessing the DX-Series
Controller
64
1 When prompted for a login, enter serviceshell and the <service
password> for the password.
Passwords are case sensitive.
Note:
2 From the Transfer menu at the top of Hyper Terminal, select the Capture
Text...
3 Enter a file name and click Start.
4 At the command prompt, type /hurricane/collect and press <Enter>.
5 After the command has executed, select Stop from the Capture Text
menu.
The DX-Series system is now initially configured and ready to be accessed
via the management web pages. Disconnect the cable from the DX-Series
controller serial port.
Accessing the DX-Series controller consists of the following steps:
0
•
Setting Up the Service PC
•
Connecting the Service PC to the Network
Setting Up the Service PC
To setup the service laptop to communicate with the DX-Series system:
1 From Windows desktop, right-click on
2 Under the
Protocols
3 Click
Properties
4 Set the IP address so that the last digit of the address is one number less
than the active IP address.
Example: If the active IP address is 192.168.54.45, set the TCP/IP properties IP
address to 192.168.54.44.
5 Set the network mask to 255.255.255.0
6 Set the Default Gateway (if necessary) so that the last digit of the active IP
address is 1.
Example: If the active IP address is 192.168.54.45, set the default gateway to
192.168.54.1. Click Apply.
Reboot the service laptop.
Configuring the DX-Series System
Network Neighborhood
tab, highlight the TCP/IP adapter.
.
0
.
Advertisement
Table of Contents
