Table of Contents
Advertisement
Quantum DX-Series System Unpacking and Installation Instructions
Document 6513502-06 A01
October 2006
Figure 51 Connecting the
Service PC to the
DX-Series Controller
58
Connecting to the DX-Series Controller
To initially configure the DX-Series system:
1 Connect a 9-pin RS-232 null modem cable to the COM port in the left-
most PCI slot the back of the DX-Series controller and to a COM port on
the service PC (see
figure
2 Open a HyperTerminal window on the service PC and set the following
properties:
•
Baud rate
•
Data bits
•
Parity
•
Stop bits
•
Flow control
•
Emulation
Configure Service Options
To configure the service options:
1 Press <Enter> to access the command prompt.
2 At the command prompt, type service and press <Enter>.
The system prompts you for a password.
3 Type the <service password> and press <Enter>.
The system displays the DX-Series Service Menu (see
Configuring the DX-Series System
51).
Serial port
115200
8
none
1
none
ANSI
0
DX30 shown
0
figure
52).
Advertisement
Table of Contents
