Table of Contents
Advertisement
Table 8 DX100 Fibre
Channel and Cabling
(Storage Arrays 1 through 8)
Quantum DX-Series System Unpacking and Installation Instructions
The medium changer (robot) and three virtual tape drives, by
Note:
default, are presented on port 5 and the remaining three
virtual tape drives are presented on port 6. Refer to
Configuring the Fibre Channel Settings
description of how to re-map the devices to Fibre Channel
ports.
Connection
From:
Storage array 1
Primary connection module
FC- Ch0 (right-hand port)
Secondary connection module
FC- Ch1 (left-hand port)
Storage array 2
Primary connection module
FC- Ch0 (right-hand port)
Secondary connection module
FC- Ch1 (left-hand port)
Storage array 3
Primary connection module
FC- Ch0 (right-hand port)
Secondary connection module
FC- Ch1 (left-hand port)
Storage array 4
Primary connection module
FC- Ch0 (right-hand port)
Secondary connection module
FC- Ch1 (left-hand port)
Storage array 5
Primary connection module
FC- Ch0 (right-hand port)
Secondary connection module
FC- Ch1 (left-hand port)
Storage array 6
Primary connection module
FC- Ch0 (right-hand port)
Secondary connection module
FC- Ch1 (left-hand port)
Storage array 7
Primary connection module
FC- Ch0 (right-hand port)
Secondary connection module
FC- Ch1 (left-hand port)
Cabling the DX-Series System
Document 6513502-06 A01
October 2006
on page 75 for a
To:
FC switch 1, port 2
FC switch 1, port 12
FC switch 1, port 7
FC switch 1, port 17
FC switch 1, port 3
FC switch 1, port 13
FC switch 1, port 8
FC switch 1, port 18
FC switch 1, port 4
FC switch 1, port 14
FC switch 1, port 9
FC switch 1, port 19
FC switch 1, port 5
FC switch 1, port 15
47
Advertisement
Table of Contents
