Table of Contents
Advertisement
Quantum DX-Series System Unpacking and Installation Instructions
Document 6513502-06 A01
October 2006
Configuring the
0
Network Information
70
7 Enter the number of empty bins available in addition to the number of
cartridges created in the partition. The default number of empty bins is 0
and up to 28 empty bins can be selected.
8 Select the number of tape cartridges from the
and click the right arrow button to move the cartridges into the partition.
If all tape cartridges are assigned to other partitions, you must
Note:
unassign one or more tape cartridges to make them available
for a new partition. Be aware that all cartridges that were
created at the time of installation are assigned to the Default
partition.
9 Click
to create the partition.
Apply
Map the Fibre Channel ports as described in
Channel Settings
on page 75.
10 Return the DX-Series system to the online state from the
The partition is added to the partition list. To add another partition,
repeat this procedure.
For more information on adding, editing, or deleting a
Note:
partition, see the DX-Series User's Guide (PN 6513501).
If you have not configured the network information, configure the network
information via the following web pages:
1 To access the
Network Configuration
click
.
Network
The management frame displays the
figure
59).
Configuring the DX-Series System
Available Tape Cartridge
Configuring the Fibre
Utilities
page, from the
Configuration
page (see
Network Configuration
list
page.
page,
Advertisement
Table of Contents
