Quantum DX100 Unpacking And Installation Instructions page 33

Figure 29 Removing the
AC Power Connector
Screws
Figure 30 Installing the
Cable Clamp and Power
Cable
Quantum DX-Series System Unpacking and Installation Instructions
Screws
2 Install the cable clamp on the power sequencer using two pan head
PHILLIPS screws provided in the accessory kit (see
Screws
Cable clamp
3 Install the AC power cable through the cable clamp and into the AC
power sequencer. Tighten the cable clamp with the tension screw to
secure the power cable (see
A rubber shim is included with the cable clamp for power
Note:
cables smaller than the cable clamp.
Installing the DX-Series System
Document 6513502-06 A01
AC power connector
figure 31).
October 2006
figure 30).
33