Quantum DX100 Unpacking And Installation Instructions page 25

Figure 18 Sliding the Fibre
Channel Switch into the
Support Brackets
Installing the Ethernet
0
Switch (DX100 Only)
Quantum DX-Series System Unpacking and Installation Instructions
Switch may be visually different
Fibre Channel switch
6 Install 2U blank-off plate in front of rack covering the space taken by the
Fibre Channel switch and Ethernet switch.
Install two 10-32 x .50 in. screws in the rack under the right
Note:
and left top corners of the 2U blank-off plate.
Repeat this procedure for an additional Fibre Channel switch in a second
rack to support more than 8 storage arrays.
To install the Ethernet switch:
To accommodate the Ethernet cabling connections, the Ethernet
Note:
switch must be installed with the ports facing the back of the rack.
1 Install the mounting ears on to the Ethernet switch with three PHILLIPS
screws on each side (see
Installing the DX-Series System
figure 19).
Document 6513502-06 A01
October 2006
25