Quantum DX100 Unpacking And Installation Instructions page 79

Table 12 Email
Notification
Quantum DX-Series System Unpacking and Installation Instructions
Field Description
When a hardware failure occurs on the DX-Series
Message Type:
system such as a transition to a degraded, limited
Hardware Failure
access, or failed system state, an email is sent to
everyone on the hardware failure recipient list.
When a configuration change is made on the
Message Type:
DX-Series system such as changing a bar code
Configuration
label or network configuration, an email is sent to
Changes
everyone on the configuration changes recipient
list.
When an operator access occurs on the DX-Series
Message Type:
system such as starting up or shutting down the
Operator Access
system, an email is sent to everyone on the
operator access recipient list.
When a soft error has occurred on the DX-Series
Message Type:
system such as an attention state (high
Soft Error
temperature warning), an email is sent to
everyone on the soft error recipient list.
Future enhancement
Message Type:
Administrative
To add a new recipient to a specific list, type the
New Recipient
email address of the new recipient in the field
and click Add.
Each message type has a recipients list that is
Recipients
viewed by clicking on the specific drop-down
box. To remove a recipient, select the individual
email address from the list and click Remove.
To send an email notification to Quantum
Send to
Corporation as well as the recipients list, select
Quantum?
the Send to Quantum check box for the specific
message type. The company and contact
information is sent to Quantum as an attachment
to this email.
Configuring the DX-Series System
Document 6513502-06 A01
October 2006
79