Quantum DX-Series System Unpacking and Installation Instructions
Document 6513502-06 A01
October 2006
Figure 28 Installing the
Hold Down Bracket
Assembly
Left mounting bracket
Hold down bracket
32
3 Install the hold down mounting assembly with five PHILLIPS screws on
each side of the power sequencer (see
Cabling and Installing the AC Power Sequencer
To simplify installation, the power cords for the AC power sequencer,
controller, Ethernet switch, Fibre Channel switch, and storage arrays must be
installed outside of the rack. After all cords have been connected, the power
sequencers are installed.
To cable and install the AC power sequencers:
1 Remove the two PHILLIPS screws securing the power connector to the
power sequencer (see
Installing the DX-Series System
figure
28).
figure
29).
Right mounting bracket
0