Running The Valueloader System Test; Retrieving Information About The Valueloader; Cycle Count - Quantum ValueLoader DLT VS160 User Manual

Running the ValueLoader System Test

Retrieving Information About the ValueLoader

Cycle Count

3
ValueLoader DLT VS80/DLT VS160 Tape Autoloader User Manual
The System Test option cycles the ValueLoader through the process of
loading, calibrating, and unloading all cartridges in the carousel.
Running a System Test verifies the operational soundness of both the
ValueLoader and tape drive. The System Test continues indefinitely until
you press the
[Cancel]
are suspended while a System Test is in progress.
Note: At least one cartridge must be in inventory before running
System Test.
To run a System Test:
1 From the Home screen or main menu, press the
appears on the top line of the LCD screen. Press the
Diagnostics
button to select.
2 appears on the LCD screen. Press the
System Test
begin the test.
The displays the number of load-calibrate-unload cycles
Test Count
that have been completed during the test.
3 Press the
[Cancel]
The menu provides access to information about the
Information
ValueLoader, including the cycle count, event log, and firmware revision.
This option displays the total system cycle count, incrementing each time
a tape is loaded into the drive or exported from the ValueLoader.
To use this option, follow these steps:
Running the ValueLoader System Test
button. All regular backup and restore operations
button to end the test.
ValueLoader Administration
or button until
[+] [–]
[Enter]
button to
[Enter]
3
3
39