Camera - Polycom VSX3000 Integrator's Reference Manual

camera

Sets or gets the near-site or far-site camera settings.
Syntax
camera near {1..4}
camera far {1..5}
camera <near|far> move <left|right|up|down|zoom+|zoom-|stop>
camera <near|far> move <continuous|discrete>
camera <near|far> source
camera <near|far> stop
camera <near|far> tracking <get|on|off|to_presets>
camera near <getposition|setposition "x" "y" "z">
camera <register|unregister>
camera register get
Parameter
near
far
{1..4}, {1..5}
move
left
right
up
down
zoom+
zoom-
stop
continuous
discrete
source
Description
Specifies that the command selects or controls the
near camera.
Specifies that the command selects or controls the far
camera.
Specifies a near or far camera as the main video
source.
Changes the near or far camera's direction or zoom.
Only continuous and discrete return feedback. Valid
directions are: left, right, up, down, zoom+, zoom-,
stop, continuous, and discrete.
Starts moving the camera left.
Starts moving the camera right.
Starts moving the camera up.
Starts moving the camera down.
Starts zooming in.
Starts zooming out.
Stops the near or far camera when in continuous
mode. Returns no feedback.
Selects continuous movement mode. The camera will
move in direction specified until a camera <near|far>
move stop command is sent.
Selects discrete movement mode. The camera will
move a small amount in the direction specified and
then stop. No stop command is required.
Returns the number of the near or far camera source
currently selected.
System Commands
4 - 41