Dcdfilter - Polycom VSX3000 Integrator's Reference Manual

dcdfilter

Sets or gets the filter setting of the DCD serial interface control signal (data
carrier detect). This command is only applicable if you have a V.35 network
interface connected to your system.
Syntax
dcdfilter <get|on|off>
Parameter
get
on
off
Feedback Examples
• dcdfilter on
• dcdfilter off
Comments
When this filter is enabled, DCD drops for 60 seconds before changing the call
state. The default setting for this signal is
User interface screen location: System > Admin Settings > Network >
V.35/RS-449/RS-530 (page 3): Delayed DCD hangup
Description
Returns the current setting.
Enables the DCD filter.
Disables the DCD filter.
.
"off"
System Commands
4 - 61