Dcd - Polycom VSX3000 Integrator's Reference Manual

Integrator's Reference Manual for the VSX Series

dcd

4 - 60
Sets or gets the configure for the DCD serial interface control signal (data
carrier detect). This command is only applicable if you have a V.35 network
interface connected to your system.
Syntax
dcd <get|normal|inverted>
Parameter
get
normal
inverted
Feedback Examples
• dcd normal
• dcd inverted
Comments
The default setting for this signal is
User interface screen location: System > Admin Settings > Network >
V.35/RS-449/RS-530 (page 3): DCD
Description
Returns the current setting.
Sets the signal to normal (high voltage is logic 1).
Sets the signal to inverted (low voltage is logic 1).
.
"normal"