SMC Networks HRR018-A-10 Series Operation Manual page 101

Contact output signal 1 Select maintenance
16.
Press the [▼] key. Displays screen for setting the selected maintenance for the
Contact output signal 1. The alarm is valid when the "selected maintenance status
signal output" is active.
Select the maintenance alarm No. to be allocated to Contact output signal 1.
●Setting range: MT.01 to MT.05 (Initial value: MT.01)
Contact output signal 2 Select function
17.
Press the [▼] key. Displays screen for setting the function for the Contact output signal
2.
Displays the function for the Contact output signal 2.
Set value
No output signal
Operation status signal output
Remote status signal output
Unused
Ready completion (TEMP READY) signal output
TEMP OUT (temperature is out of the range) signal output
FLT (operation stop) alarm signal output
WRN (operation continue alarm) signal output
Notice for maintenance signal output
Alarm status signal output
Pass through signal of the contact input signal 1
Pass through signal of the contact input signal 2
Selected alarm status signal output
Selected notice for maintenance signal output
HRR Series
Chapter 5 Display and Setting of Various Functions
Contact output signal 1 Selected maintenance alarm No.
DOUT1 ⇒ MANT ⇒ CODE( Alternately displayed )
Contact output signal 2 function
DOUT2 ⇒ SEL( Alternately displayed )
Explanation
HRX-OM-W002
Initial value
(Default setting)
―
―
○
―
―
―
―
―
―
―
―
―
―
―
5.5 Advanced setting mode
5-51