Switching Group Relay - Siemens Synco living QAX913 Mounting And Commissioning

Switching group 1 - 4
Switching group 5 - 8
Prior to changing an already defined switching group function, all RF
devices connected to the switching group must be disconnected (see
page 86). Disconnect and deactivate any connected switching group
relay before switching group function "Switch" can be changed.
Per default, info pages 1 – 8 are assigned to the 4 pairs of softkeys.
Changes to info page numbers are possible at the user level. (See
operating instructions via info page direct selection).
The central apartment unit transmits the switching group commands to the
switching group actors – via RF and the wired bus. The output signal can be
forwarded to the following types of devices:
Switching group function
Switch, Dim
Blind
Scene
* Connection of the respective S-Mode objects of the central apartment unit to the relevant S-Mode de-
vices on KNX TP1 via commissioning tool (ETS).

Switching group relay

Switching groups with selected "Switch" function can be assigned a relay out-
put.
Specify if a switching group relay is used and how it is controlled.
Main menu > Commissioning > Basic configuration
> Switching groups > Switching group X > Relay output:
30 / 134
Siemens
Building Technologies
Factory setting
Info
--- (Inactive)
Supported types of devices/suppliers
Switching and dimming devices:
• RF adapter plugs KRF96...
• Siemens: GAMMA wave
• Hager: tebis radio
• Any brand: S-mode KNX TP1 *
Blinds devices:
• Siemens: GAMMA wave
• Hager: tebis radio
• Any brand: S-mode KNX TP1 *
Scene-compatible switching and dimming de-
vices:
• RF adapter plugs KRF96...
• Siemens: GAMMA wave
• Hager: tebis radio
• Any brand: S-mode KNX TP1 *
Synco™ living
Commissioning the system
CE1C2740en
13.12.2010