Installing The Cisco Ucs Invicta C3124Sa Appliance In A Rack; Installing The Slide Rails - Cisco UCS Invicta C3124SA Installation Manual

Chapter 2 Installing the Cisco UCS Invicta C3124SA Appliance

Installing the Cisco UCS Invicta C3124SA Appliance In a Rack

This section contains the following sections:
•
•
•
•

Installing the Slide Rails

Warning To prevent bodily injury when mounting or servicing this unit in a rack, you must take special
precautions to ensure that the system remains stable. The following guidelines are provided to ensure
your safety:
This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the heaviest component
at the bottom of the rack.
If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing the unit in the rack.
Statement 1006
To install the slide rails and the Cisco UCS Invicta C3124SA Appliance into a rack, follow these steps:
Install the slide rails into the rack (see
Step 1
a.
b.
OL-31369-01
Installing the Slide Rails, page 2-5
CIMC Setup and Configuration, page 2-7
Connectivity, page 2-8
Powering On, page 2-9
Align the slide-rail assembly inside the rack posts with the length-adjustment bracket
item 4) toward the rear of the rack.
Compress the length-adjustment bracket until the mounting pegs (item 5) and locking clips (item 6)
engage the desired rack holes on the front and rear rack posts.
The mounting pegs fit square 0.38-inch (9.6 mm), round 0.28-inch (7.1 mm), or #12-24 UNC
–
threaded holes. They fit the shape of the hole when the pegs are compressed.
The smaller #10-32 round mounting pegs are enclosed in the center of the compressible rear
–
pegs. However, to use the #10-32 pegs, you must use a bladed screwdriver to remove the
square/round front pegs.
Installing the Cisco UCS Invicta C3124SA Appliance In a Rack
Figure 2-1):
Cisco UCS Invicta C3124SA Appliance Installation Guide
(Figure 2-1,
2-5