Appendix; Installation For Cisco Ucs Integration; Installing A Release 1.2(2) Or Later Server For Cisco Ucs Integration - Cisco UCS C200 Installation And Service Manual

S e n d d o c u m e n t c o m m e n t s t o u c s - d o c f e e d b a c k @ c i s c o . c o m

Installation for Cisco UCS Integration

This appendix contains information and procedures for installing a Cisco UCS C200 server for
integration with the Cisco Unified Computing System (UCS).
In this integration, the server is not managed by its standalone Cisco Integrated Management Controller
(CIMC) GUI or CLI commands because it is instead managed through the Cisco UCS Manager software.
This appendix contains the following sections:
•
•
•
Installing a Release 1.2(2) or Later Server for Cisco UCS
Integration
Servers that are Release 1.2(2) and later already have the prerequisite firmware and settings so that they
are ready to be connected to the Cisco UCS environment immediately.
This procedure describes how to connect the Cisco UCS C-Series server to your preconfigured network.
Preconfiguration of your network and networking equipment is beyond the scope of this document, but
see the following URLs for documentation.
•
•
OL-20732-02
Installing a Release 1.2(2) or Later Server for Cisco UCS Integration, page D-1
Upgrading a Server Earlier Than Release 1.2(2) for Cisco UCS Integration, page D-5
Supported Network Adapter Card Combinations for UCSM Mode, page D-10
For information about installing, configuring, and using the Cisco UCS 6100 Series fabric
interconnects (switches) in the configuration, see the documentation at the following URL:
http://www.cisco.com/en/US/products/ps10276/tsd_products_support_series_home.html
For information about installing, configuring, and using the Cisco Nexus 2248 fabric extenders in
the configuration, see the documentation at the following URL:
http://www.cisco.com/en/US/products/ps10110/tsd_products_support_series_home.html
A P P E N D I X
Cisco UCS C200 Server Installation and Service Guide
D
D-1