Chapter 3: Jumpers And Connectors; Before You Begin; Precautions - Nexcom VTC 1011 Series User Manual

Vehicle telematics computer
Table of Contents

Advertisement

Chapter 3: Jumpers and Connectors

C
3: J
haPter
umPers and
This chapter describes how to set the jumpers and connectors on the
VTC 1011 series motherboard.

Before You Begin

▪ Ensure you have a stable, clean working environment. Dust and dirt can
get into components and cause a malfunction. Use containers to keep
small components separated.
▪ Adequate lighting and proper tools can prevent you from accidentally
damaging the internal components. Most of the procedures that follow
require only a few simple tools, including the following:
– A Philips screwdriver
– A flat-tipped screwdriver
– A set of jewelers screwdrivers
– A grounding strap
– An anti-static pad
▪ Using your fingers can disconnect most of the connections. It is
recommended that you do not use needle-nosed pliers to disconnect
connections as these can damage the soft metal or plastic parts of the
connectors.
▪ Before working on internal components, make sure that the power is off.
Ground yourself before touching any internal components, by touching
a metal object. Static electricity can damage many of the electronic
components. Humid environments tend to have less static electricity than
Copyright © 2023 NEXCOM International Co., Ltd. All Rights Reserved.
C
onneCtors
dry environments. A grounding strap is warranted whenever danger of
static electricity exists.

Precautions

Computer components and electronic circuit boards can be damaged by
discharges of static electricity. Working on computers that are still connected
to a power supply can be extremely dangerous.
Follow the guidelines below to avoid damage to your computer or yourself:
▪ Always disconnect the unit from the power outlet whenever you are
working inside the case.
▪ If possible, wear a grounded wrist strap when you are working inside the
computer case. Alternatively, discharge any static electricity by touching
the bare metal chassis of the unit case, or the bare metal body of any
other grounded appliance.
▪ Hold electronic circuit boards by the edges only. Do not touch the
components on the board unless it is necessary to do so. Don't flex or
stress the circuit board.
▪ Leave all components inside the static-proof packaging that they shipped
with until they are ready for installation.
▪ Use correct screws and do not over tighten screws.
19
VTC 1011 Series User Manual

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vtc 1011-c2kVtc 1011-c2vk

Table of Contents