Audio Cross Channel Editing - Panasonic AJ-LT95 Operating Instructions Manual

Audio cross channel editing

Audio cross channel editing using the internal audio
memory can be performed by connecting an external
audio mixer.
$ Example of operation
Recording cross-faded audio signals onto CH2
AUDIO OUT
(CH1 or CH2)
Process 1
1
Select "INT_X" as the setup menu item No.317
(AUD MEM MODE) setting.
"m" now appears on the superimposed display of
VTR2. (See page 85)
2
Select CH2 as the setup menu item No.318 (AUD
MEM CH) setting.
3
Press the A1 and A2 buttons to turn on their lamps.
(CH1 and CH2 audio insert)
4
Set the edit points of VTR1 and VTR2.
5
Operate the audio mixer in such a way that the
VTR1 output signals (which are supplied to INPUT
A of the audio mixer) are output from the MIXER
CH1 OUT and MIXER CH2 OUT connectors.
(Turn down the input to INPUT B of the audio
mixer.)
INPUT
A
INPUT
B
Audio mixer
INPUT
A
INPUT
B
Audio mixer
VTR1
AJ-LT95
MIXER
CH1 OUT
MIXER
CH2 OUT
66
<Note>
Sound can be recorded on CH1 and CH2 channels
only.
MIXER
CH1 OUT
MIXER
CH2 OUT
AUDIO AUDIO
CH1 OUT CH2 IN
Internal
memory
VTR2
6
Press the AUTO EDIT button to execute editing.
The same sound (VTR1 output) is insert recorded
onto CH1 and CH2 of VTR2. The same sound that
is recorded for about 20 seconds before the OUT
point is also stored in the internal memory at this
time.
IN
point
CH1
CH2
Internal memory
AUDIO
CH1 IN
OUT
point
Approx.
20 sec