Panasonic AJ-LT95 Operating Instructions Manual page 34

Setup menus
OPERATION menu
Item
Superimposed
No.
display
110 MEMORY STOP
170 HUMID OPE
171 ALL STOP SEL
172 VTR1 IN SEL
173 BATTERY SEL
174 SDI OUT
The underlining indicates the factory setting.
Setting
Superimposed
No.
display
This selects the processing to be conducted when the counter
displays zeros in the CTL mode or during FF or REW.
0000 OFF 0: The VTR is not shut down.
0001 ON 1: The VTR is automatically shut down.
<Note>
O For the stop mode, either the stop or still-picture (SHTL + 0.0,
JOG STILL) mode is set depending on the setup menu item
No.315 (AFTER CUE-UP) setting.
O When both the AUTO REW function and MEMORY function
have been selected, the AUTO REW function takes priority.
This selects whether the unit is to continue operating when
condensation has formed.
0000 OFF 0: The unit does not operate.
0001 ON 1: It operates even when condensation has formed but no
guarantees are made for its operation.
<Note>
Since tape damage or other problems may occur when "1: ON"
has been selected, the "0: OFF" setting should normally be used.
This selects the unit's mode to be established when the ALL
STOP button has been pressed.
0000 STOP 0: The unit is set to the STOP mode.
0001 STILL 1: The unit is set to the still-picture (SHTL + 0.0, JOG STILL)
mode.
This selects the VIDEO/AUDIO input of VTR1 when the analog
signal input has been selected.
0000 V1 IN 0: VTR1 IN serves as the VTR1 input.
0001 V2 IN 1: VIDEO IN and AUDIO IN of VTR2 serve as the VTR1 input.
<Notes>
O The unit will not operate when SDI signal input has been
selected.
O This operation is not performed in the 625i mode.
This selects the voltage threshold for warning when the DC supply
voltage has dropped.
(The unit's power is automatically turned off when it drops to 10.6
V.)
0000 10.8V 0: When it has dropped to 10.8 V
0001 11.0V 1: When it has dropped to 11.0 V
0002 11.2V 2: When it has dropped to 11.2 V
0003 11.4V 3: When it has dropped to 11.4 V
0004 11.6V 4: When it has dropped to 11.6 V
0005 11.8V 5: When it has dropped to 11.8 V
0006 12.0V 6: When it has dropped to 12.0 V
0007 12.5V 7: When it has dropped to 12.5 V
0008 13.0V 8: When it has dropped to 13.0 V
This selects the SDI output.
0000 VTR1 0: The VTR1's signals are output.
0001 VTR2 1: The VTR2's signals are output.
34
Description of setting
V V
T T
R R
1 2
[ [
[
[
[
[
[