Panasonic AJ-LT95 Operating Instructions Manual page 42

Setup menus
TIME CODE menu
Item
Superimposed
No.
display
506 BINARY GP
507 PHASE CORR
508 TCG CF FLAG
509 DF MODE
511 VITC OUT
570 REGEN SEL
The underlining indicates the factory setting.
Setting
Superimposed
No.
display
This selects the usage status of the user's bit in the time code
generated by the TCG.
0000 000 0: Not specified (character set is not specified).
0001 001 1: ISO characters (8-bit character set complying with ISO646,
ISO2022)
0002 010 2: Unassigned 1 (not defined)
0003 011 3: Unassigned 2 (not defined)
0004 100 4: Unassigned 3 (not defined)
0005 101 5: Page/line
0006 110 6: Unassigned 4 (not defined)
0007 111 7: Unassigned 5 (not defined)
This selects whether the phase correction for the LTC generated
by the TCG is to be controlled.
0000 OFF 0: Phase correction is not controlled.
0001 ON 1: Phase correction is controlled.
This selects the color framing flag into the TCG.
0000 OFF 0: The color framing flag is set to OFF.
0001 ON 1: The color framing flag is set to ON.
This selects the CTL and TCG drop frame mode.
0000 DF 0: For operation in the drop frame mode.
0001 NDF 1: For operation in the non-drop frame mode.
<Note>
In the 625i mode, this setup menu item does not appear.
This selects the method used to output the VITC which is
superimposed onto the output video signal.
0000 SBC 0: During recording:
The input time code set by setup menu item No.570 (REGEN
SEL) or the TC generator switch is output as the VITC.
During playback:
The time code recorded in the SBC area is output as VITC.
0001 VAUX 1: During recording:
The time code detected from among the input video signals is
output as VITC.
During playback:
The time code recorded in the VAUX area is output as VITC.
<Note>
The time code detected from among the input video signals is
automatically output as VAUX when pictures are recorded.
This selects whether the internal TCG or external time code is to
be used when the REGEN/PRESET switch has been set to the
REGEN position.
0000 I-REG 0: The internal TC is used in the regeneration mode.
0001 E-VITC 1: The input video signal VITC is used in the regeneration mode.
0002 E-LTC 2: The LTC in the TC input is used in the regeneration mode.
0003 VTR1TC 3: The sub-code TC is used in the regeneration mode when the
OPERATION MODE switch is set to INT.
<Note>
The VTR1 TC can be set only on the VTR2 side.
42
Description of setting
V V
T T
R R
1 2
[ [
[ [
[ [
[ [
[ [
[ [