Panasonic AJ-LT95 Operating Instructions Manual page 21

Parts and their functions
Editing operation area
D AUTO EDIT/END (MULTI EDIT) button
AUTO EDIT/END:
Press this button to initiate automatic editing.
When editing was initiated without setting the
OUT point (open-ended editing), press this
button to end the editing and store the point at
which the button was pressed as the OUT point.
MULTI EDIT ([SHIFT] + [AUTO EDIT]):
Press this button while holding down the SHIFT
button to initiate multi-event editing. Multi-event
editing is now executed automatically until the
last event is edited or until the operation is
forcibly ended by pressing the ALL STOP button.
E PREVIEW (REVIEW) button
PREVIEW:
Press this button to rehearse the editing.
REVIEW ([SHIFT] + [PREVIEW]):
Press this button while holding down the SHIFT
button to check the results of the editing.
F D
POWER
AUDIO MONITOR SELECT
OFF ON
MIX 4 MIX 4
3 3
CH 1 CH 2 CH 3 CH 4 (V1·2)
UNI 2 2 V1
V1/V2 MIX 1 MIX 1
ANALOG L R
REC
VAR
G I J
E
V2
CH 3 4
H
F SPLIT button
Press this button to initiate split editing.
Check that its LED has lighted, and set the split IN
point.
G MARK IN button
Press this button to set an edit IN point by reading
the VTR's time code or CTL.
Press it while holding down the SHIFT button to set
the split IN point.
H MARK OUT button
Press this button to set an edit OUT point by
reading the VTR's time code or CTL.
I SHIFT button
To use any of the functions indicated at the bottom
of the buttons, press the button concerned while
holding down the SHIFT button.
J ALL STOP button
Press this button to shut down all the VTR's
operations.
During editing (PREVIEW, EDIT REVIEW), the
editing operation concerned is suspended.
21
CH 1 CH 2 CH 3 CH 4
V2
PB
UNI
SDI
REC
VAR
MIX 4 MIX 4 MIX 4 MIX 4
3 3 3 3
2 2 2 2
MIX 1 MIX 1 MIX 1 MIX 1
V2
INPUT
ANALOG ANALOG ANALOG ANALOG
SDI SDI SDI SDI
INT INT INT INT
10 10 10
0 0 0
10 10 10
20 20 20
30 30 30
0 0 0 0 0 0
CH 1 CH 2 CH 3 CH 4
V2 INT REC
/ V1 PB