Encoder Adjustments - Panasonic AJ-LT95 Operating Instructions Manual

Encoder adjustments

The video signals (ENCODER OUT) must be adjusted
upon completion of the system connections before
any signals are transmitted in order to conduct
accurate error-free editing.
(This adjustment may have to be repeated whenever
a connecting cable is replaced or the connections
changed.)
To adjust the encoder using the laptop:
1
Connect the units as shown below.
<Note>
O Supply the external reference signals to the
units from a sync signal generator.
O Connect composite video signals.
PLAYER (AJ-LT95)
REF
(BB)
REF
VIDEO IN
VIDEO 1
OUT
REF
(BB)
P1 IN
REF IN
PLAYER (AJ-LT95)
REF
(BB)
REF
VIDEO IN
VIDEO 1
OUT
P2 IN
RECORDER OUT
Switcher
MONITOR OUT
WFM
TV
(waveform
monitor
monitor)
COARSE FINE
H CHROMA
SC
LEVEL
SYSTEM
Sending out the
signals
VSC
(vectorscope)
75 Ω
If a waveform monitor and vectorscope are
unavailable, observe the images on a monitor and
adjust to eliminate any color shifting.
79
VIDEO
HUE SET UP
LEVEL
Make these 3 cables
equally long.