Panasonic AJ-LT95 Operating Instructions Manual page 13

Parts and their functions
CONTROL PREROLL SYNCHRO
REMOTE 7
5
LOCAL
3
EXT VTR
Panel switch area
7 ANALOG AUDIO IN switch
Used to set the allocation of the audio signals to the
4 analog audio input connectors (on the rear panel).
V1-V2 (2ch): Of the 4 inputs, the two on the VTR1
side are supplied to the VTR1's input
connectors, and the two on the VTR2
side are supplied to the VTR2's input
connectors.
V1 (4ch): The 4 inputs are allocated to the 4
channels of VTR1.
V2 (4ch): The 4 inputs are allocated to the 4
channels of VTR2.
8 ANALOG AUDIO OUT switch
Used to set the allocation of the audio signals to the
4 analog audio output connectors (on the rear
panel).
V1-V2 (2ch): Of the 4 outputs, two on the VTR1 side
are supplied to the VTR1's output
connectors, and two on the VTR2 side
are supplied to the VTR2's output
connectors.
V1 (4ch): The 4 outputs are allocated to the 4
channels of VTR1.
V2 (4ch): The 4 outputs are allocated to the 4
channels of VTR2.
VTR 1
MODE REC INHIBIT
TC
REGEN
CF
TAPE ON
R-RUN
ON
OFF EE F-RUN OFF
VTR 2 ANALOG
REC INHIBIT
MODE TC
IN
REGEN
2
TAPE ON CH
R-RUN
4
CH
EE F-RUN OFF
7
9 OPERATION MODE switch
INT: In this mode, editing from VTR1 to VTR2 is
accomplished using the internal connections.
VTR1 recording is prohibited.
EXT: In this mode, editing from VTR1 to VTR2 is
accomplished using the external analog
connections.
VTR1 recording is prohibited.
SEPARATE:
In this mode, VTR1 and VTR2 are operated
independently.
: V2 VIDEO input selector switch
Used to select the video input of VTR2 when the
OPERATION MODE switch is at the EXT or
SEPARATE position.
SDI: Serial digital video signals are input.
ANALOG: Analog video signals are input.
13
OPERATION
V2
MODE
VIDEO IN
AUDIO EDIT
OUT
SDI
INT
2
V1-V2
CH
V1
EXT
4
CH
V2
SEPARATE ANALOG
8 9 :