Panasonic AJ-LT95 Operating Instructions Manual page 22

Parts and their functions
Editing operation area
K Numeric input buttons
0, 1, 2, 3, 4, 5, 6, 7, 8, 9:
Used to set the edit data, etc. by inputting the
numeric values of the data.
C:
Used to clear the numeric values or other edit
data entered.
+/–:
Used to change the edit data or change the
settings in the setup mode, etc.
ENTER:
Used to enter the edit data, etc. as numeric
values.
DISP [SHIFT] + [0] :
Used to set the superimposing on the LCD
monitor screen ON or OFF.
DUMP [SHIFT] + [1] :
Press to transfer edit data (EDL) to an external
component.
LOAD [SHIFT] + [2] :
Press to load edit data (EDL) from an external
component into the internal EDL memory.
T SET [SHIFT] + [3] :
Used to set the time code generator's initial
values when the TC generator switch is at the
preset (R-RUN or F-RUN) position.
LIST [SHIFT] + [4] :
Used to display the edit data on the monitor
screen.
POWER
AUDIO MONITOR SELECT
OFF ON
MIX 4 MIX 4
3 3 (V1·2)
CH 1 CH 2 CH 3 CH 4
UNI 2 2 V1
V1/V2 MIX 1 MIX 1
ANALOG L R
REC
VAR
K
V2
CH 3 4
CORCT [SHIFT] + [5] :
Press to change the edit data which has already
been stored in the EDL memory.
TRACK [SHIFT] + [6] :
Press to initiate time track processing.
SET UP [SHIFT] + [7] :
Press to perform the settings for the whole
system.
The setup menus appear on the monitor screen.
DIAG [SHIFT] + [9] :
Used to display the DIAG MENU, etc.
F/TC [SHIFT] + [ ] :
Used to select whether the numeric values will
be input in time codes or in frames when these
values are to be input.
FS [SHIFT] + [+] :
Press to change to the next event.
BS [SHIFT] + [–] :
Press to change to the previous event.
EXIT [SHIFT] + [C] :
Press to stop the input of the edit points or other
data at any time.
In the setup mode, this discards the settings and
exits the setup mode.
RETURN [SHIFT] + [ENTER] :
Press to stop the input of the edit points or other
data at any time.
In the setup mode, this enters the settings.
22
CH 1 CH 2 CH 3 CH 4
V2
PB
UNI
SDI
REC
VAR
MIX 4 MIX 4 MIX 4 MIX 4
3 3 3 3
2 2 2 2
MIX 1 MIX 1 MIX 1 MIX 1
V2
INPUT
ANALOG ANALOG ANALOG ANALOG
SDI SDI SDI SDI
INT INT INT INT
10 10 10
0 0 0
10 10 10
20 20 20
30 30 30
0 0 0 0 0 0
CH 1 CH 2 CH 3 CH 4
V2 INT REC
/ V1 PB