Time Code Menu - Panasonic AJ-LT95 Operating Instructions Manual

Setup menus

TIME CODE menu

Item
Superimposed
No.
display
500 VITC BLANK
501 VITC POS-1
(525i mode)
(625i mode)
502 VITC POS-2
(525i mode)
(625i mode)
503 TCG REGEN
504 REGEN MODE
The underlining indicates the factory setting.
Setting
Superimposed
No.
display
This selects whether to output the VITC signal at the positions
which have been set by setup menu item No.501 (VITC POS-1)
and No.502 (VITC POS-2).
0000 BLANK 0: The VITC signal is not output.
0001 THRU 1: The VITC signal is output.
0000 10L This selects the position where the VITC signal is inserted.
<Note>
0006 16L The same line as the one selected by setup menu item No.502
(VITC POS-2) cannot be set.
0010 20L
0000 7L
0004 11L
0015 22L
0000 10L This selects the position where the VITC signal is inserted.
<Note>
0008 18L The same line as the one selected by setup menu item No.501
(VITC POS-1) cannot be set.
0010 20L
0000 7L
0006 13L
0015 22L
This selects the signal to be regenerated when the TCG (time
code generator) is in the regeneration mode.
0000 TC&UB 0: Both the time code and user's bit are regenerated.
0001 TC 1: Only the time code is regenerated.
0002 UB 2: Only the user's bit is regenerated.
This selects when the time code is to be regenerated during
automatic editing (assemble editing or insert editing).
0000 AS&IN 0: The time code is regenerated in assemble editing or insert
editing.
0001 ASSEM 1: The time code is regenerated in assemble editing.
0002 INSRT 2: The time code is regenerated in insert editing.
0003 SW 3: The time code regeneration accords with the REGEN/PRESET
switch position.
41
Description of setting
V V
T T
R R
1 2
[ [
[ [
[ [
[ [
[