Parts And Their Functions; Panel Control Area - Panasonic AJ-LT95 Operating Instructions Manual

Parts and their functions

1
2
3
4

Panel control area

1 Audio monitor speakers
The sound of the VTR1 (or VTR2) signals to be
monitored is delivered through the VTR1 (or VTR2)
speaker.
Depending on the positions selected for the AUDIO
MONITOR SELECT switches, VTR1 or VTR2
sound is selected and output.
2 LCD switch
This functions as the LCD monitor power switch,
and it also selects the brightness of the display's
backlight.
LIGHT: For increasing the display's backlight
brightness.
DARK: For reducing
brightness.
OFF: The LCD monitor is turned off.
3 BRIGHTNESS control
Used to adjust the brightness of the LCD monitor.
4 COUNTER/REMAIN switch
This is used to switch what is to be shown on the
display tube and the superimposed display position
on the monitor screen.
Each time the switch is pressed, the display is
changed in the sequence presented below.
BACKLIGHT
LIGHT
DARK
OFF
BRIGHTNESS
COUNTER/
REMAIN
CH CONDITION
METER
FULL/
FINE
RESET
CTL
TC
UB
VTR 1
CONTROL PREROLL SYNCHRO MODE
TC
REMOTE 7 CF REGEN
TAPE
R-RUN
LOCAL 5 ON
EE
EXT VTR 3 OFF F-RUN
M-cassette
EJECT
Caution Do not Insert S-cassette or with adaptor
<
VTR 1
the display's backlight
EVENT
CH CONDITION
V1 V2
OPERATION
VTR 2 ANALOG
V2
MODE
REC INHIBIT REC INHIBIT AUDIO EDIT VIDEO IN
MODE TC
IN OUT
SDI
REGEN 2 2 INT
CH V1-V2 CH
ON TAPE ON
R-RUN
4 V1 4 EXT
CH CH
OFF EE F-RUN OFF V2
SEPARATE ANALOG
M-cassette
Caution Do not Insert S-cassette or with adaptor
VTR 2
7
1
LEVEL ·
BACKLIGHT 2
LIGHT
DARK
OFF
BRIGHTNESS
3
COUNTER/
4
REMAIN
METER
FULL/
FINE
RESET
CTL
TC
UB
EJECT
<
Counter/operation mode
display (top position)
Counter display
No on-screen display
Counter display
Counter/operation mode
display (bottom position)
DC voltage/remaining tape
display
("11.8V/82 minutes" is
indicated in the figure.)
Counter/operation mode
display (bottom position)
Counter display