Rear Hot-Swap Drive Assembly Replacement; Remove The Rear Hot-Swap Drive Assembly - Lenovo ThinkSystem SR650 Maintenance Manual

Step 4. Reinstall the riser assembly. Ensure that the GPU assembly is secured onto the air baffle.
Figure 123. GPU assembly installation
After installing the GPU, complete the parts replacement. See "Completing the parts replacement" on page
203.

Rear hot-swap drive assembly replacement

Use this information to remove and install the rear hot-swap drive assembly.
The rear hot-swap drive assembly enables you to install up to two 3.5-inch hot-swap drives in the rear of the
server.
Notes:
• The term "hot-swap drive" refers to all the supported types of 3.5-inch hot-swap hard disk drives and hot-
swap solid-state drives.
• The rear hot-swap drive assembly is available on some models.

Remove the rear hot-swap drive assembly

Use this information to remove the rear hot-swap drive assembly.
Before removing the rear hot-swap drive assembly:
1. Remove the top cover. See "Remove the top cover" on page 103.
2. Remove the drives or drive fillers installed in the rear hot-swap drive assembly. See "Remove a hot-
swap drive" on page 120.
160
ThinkSystem SR650 Maintenance Manual