Remove The Rear 2.5-Inch Drive Cage - Lenovo HR650X V2 User Manual

Remove the rear 2.5-inch drive cage

Use this information to remove the rear 2.5-inch 4-bay drive cage.
About this task
Attention:
• Read "Installation Guidelines" on page 25 to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Procedure
Step 1. Prepare your server.
a. Remove the top cover. See "Remove the top cover" on page 30.
b. Disconnect the cables of the rear drive backplane from the system board or RAID/HBA
adapter.
c. Remove all the installed drives and fillers (if any) from the drive bays. See "Remove a hot-swap
drive" on page 28.
Step 2. Remove the rear drive cage.
a. Loosen the thumb screw.
b. Slide the drive cage towards the rear of the chassis to release it.
Figure 37. Removing the 4 x 2.5-inch rear drive cage
After you finish
60
HR650X V2 User Guide