Table of Contents
Advertisement
Procedure
Step 1.
Locate the hot-swap power supply in the rear of your server and disconnect the power cord from
the power supply.
Step 2.
Remove the hot-swap power supply unit.
Figure 92. Hot-swap power supply unit
a.
Press the release tab towards the handle.
b.
Carefully pull the handle to slide the hot-swap power supply unit out of the chassis.
After you finish
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Install a hot-swap power supply unit
Use this information to install a hot-swap power supply unit.
About this task
S001
.
Chapter 4
Hardware replacement procedures
107
Advertisement
Table of Contents
