Audi Q7 2007 Repair Manual page 13

Note
If using a siphoning device without shaft piece, proceed prin‐
♦
cipally in the same manner.
In this case, make a mark -arrow- on the hose -a- = 1,400 mm
♦
from end of suction hose using insulating tape. The suction
hose is inserted correctly when the marking applied earlier
aligns with the lip of the fuel filler neck.
If the hose can only be inserted with difficulty, coat it thinly with
♦
engine oil. Never use lubricants containing silicon.
– Empty fuel tank as much as possible via fuel filler tube.
– Carefully pull out the suction hose.
– Remove the left seat cushion in the second row. Refer to ⇒
Body Interior; Rep. Gr. 72 .
WARNING
Risk of injury.
♦ Wear safety gloves.
– Cut the floor covering along the perforation -arrows- on the left
side with a carpet knife -1-.
– Fold the floor covering to the side -arrow-.
– Remove nuts -1 to 4- and remove left locking flange cover.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Audi Q7 2007 ➤
Fuel Supply System - Edition 10.2018
1. Fuel Tank with Attachments
9