Audi Q7 2007 Repair Manual page 41

– Fold the floor covering to the side in direction of -arrow-.
– Remove nuts -1 to 4- and remove right locking flange cover.
– Disconnect electrical harness connector -3- at right locking
flange.
WARNING
Risk of injury from fuel.
♦ To reduce residual pressure remaining in fuel system, lay
a clean cloth around the connector and carefully loosen
connector.
– Disconnect the fuel supply line -2- from right locking flange.
– Remove locking ring with Wrench - Fuel Sending Unit -
T10202- .
– Pull right locking flange with seal out of fuel tank a bit.
– Disconnect electrical connectors -1 and 2- on underside of the
right locking flange.
Fuel Supply System - Edition 10.2018
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2. Fuel Pump, Fuel Delivery Unit and Fuel Level Sensor
Audi Q7 2007 ➤
37