Audi Q7 2007 Repair Manual page 23

10 - Fuel Supply Line
❑ To the engine
❑ To disconnect, press release button on connection piece.
❑ Clipped in on fuel tank
11 - Connector
❑ For the Fuel Level Sensor 2 - G169-
12 - Vent Line
❑ To disconnect, press release button on connection piece.
13 - Locking Ring
❑ Tighten to 110 Nm.
❑ Use a Wrench - Fuel Sending Unit - T10202- for removing and installing.
14 - Seal
❑ Always replace
❑ Install dry
15 - Butyl Adhesive Film
❑ Country-specific installation necessary
❑ Pay attention to the related campaigns/actions
16 - Left Locking Flange
❑ With gravity valve and fuel filter housing.
❑ Installed position. Refer to
❑ Fuel filter, removing and installing. Refer to
17 - Fuel Line
❑ To the fuel pressure regulator on the right side of the locking flange.
❑ To disconnect, press release button on connection piece.
18 - Fuel Line
❑ From the fuel delivery unit.
❑ To disconnect, press release button on connection piece.
19 - Fuel Level Sensor 2 - G169-
❑ Clipped in at retaining ring -19-.
❑ For checking the resistance values. Refer to
⇒ "2.12 Fuel Level Sensor 2 G169 , Checking", page 46
❑ Removing and installing. Refer to
⇒ "2.13 Fuel Level Sensor 2 G169 , Removing and Installing", page 48
20 - Retaining Ring
❑ Welded to the fuel tank.
❑ For suction jet pump and Fuel Level Sensor 2 - G169- .
21 - Rear Suction Jet Pump
❑ Removing and installing. Refer to
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
⇒ page 40 .
⇒ "3.1 Overview - Fuel Filter", page 57
⇒ "2.15 Suction Jet Pumps, Removing and Installing", page 50
Fuel Supply System - Edition 10.2018
.
.
2. Fuel Pump, Fuel Delivery Unit and Fuel Level Sensor
Audi Q7 2007 ➤
.
.
19