Suction Jet Pumps, Removing And Installing - Audi Q7 2007 Repair Manual

Audi Q7 2007 ➤
Fuel Supply System - Edition 10.2018
– Start the engine.
If the engine starts now:
– Replace suction jet pumps. Refer to
⇒ "2.15 Suction Jet Pumps, Removing and Installing",
page 50 .
2.15 Suction Jet Pumps, Removing and In‐
stalling
Special tools and workshop equipment required
♦ Wrench - Fuel Sending Unit - T10202-
Removing
Follow all safety precautions. Refer to
⇒ "1 Safety Precautions", page 1
Follow the guidelines for clean working conditions. Refer to
⇒ "2.1 Fuel Supply and Injection System, Clean Working Condi‐
tions", page 3 .
– Position driver's seat as far back and up as possible using the
full seat adjustment range.
Caution
Danger of causing damage to other electronic components
when disconnecting the battery.
♦ Complete the steps for disconnecting the battery.
– Disconnect the battery. Refer to ⇒ Electrical Equipment; Rep.
Gr. 27 .
WARNING
Danger of fuel entering vehicle interior.
♦ To remove suction jet pumps, fuel tank must be empty.
– Empty fuel tank. Refer to
⇒ "1.2 Fuel Tank, Draining", page 7
– Remove the right seat cushion in the second row. Refer to ⇒
Body Interior; Rep. Gr. 72 .
WARNING
Risk of injury.
♦ Wear safety gloves.
50
Rep. Gr.20 - Fuel Supply
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
.
with respect to the correctness of information in this document. Copyright by AUDI AG.
.