Audi Q7 2007 Repair Manual page 36

Audi Q7 2007 ➤
Fuel Supply System - Edition 10.2018
– Cut the floor covering along the perforation -arrows- on the
right side with a carpet knife -1-.
– Press the floor covering to the side and disconnect the con‐
nector -1-.
Note
Ignore -arrows-.
All Vehicles:
– Connect connector terminal -2- with an adapter cable from
Connector Test Set - VAG1594C- to chassis Ground (GND).
– Connect Injection Rate Comparison Meter Kit - Remote Cable
- VAG1348/3A- with Injection Rate Kit - Remote Cable -
VAG1348/3-3- to terminal -1- on connector.
– Cover the second connector terminal of Injection Rate Kit -
Remote Cable - VAG1348/3-3- with insulating tape to prevent
short circuit -arrow-.
– Route Injection Rate Comparison Meter Kit - Remote Cable -
VAG1348/3A- switch forward in engine compartment.
– Release the retaining clip and open the cover -A- over the
positive terminal clamp.
– Connect the alligator clip to the positive terminal clamp.
– Remove the fuel cap from the fuel filler tube.
– Pull rear engine cover off -arrows-.
32
Rep. Gr.20 - Fuel Supply
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.