Audi Q7 2007 Repair Manual page 55

– Cut the floor covering along the perforation -arrows- on the
right side with a carpet knife -1-.
– Fold the floor covering to the side in direction of -arrow-.
– Remove nuts -1 to 4- and remove right locking flange cover.
– Disconnect electrical harness connector -3- at right locking
flange.
WARNING
Risk of injury from fuel.
♦ To reduce residual pressure remaining in fuel system, lay
a clean cloth around the connector and carefully loosen
connector.
– Disconnect the fuel supply line -2- from right locking flange.
Vehicles with Auxiliary Heater:
– Also separate the fuel supply line to the auxiliary heater at the
metering pump, by pressing the release buttons.
All Vehicles
– Remove locking ring with Wrench - Fuel Sending Unit -
T10202- .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Fuel Supply System - Edition 10.2018
2. Fuel Pump, Fuel Delivery Unit and Fuel Level Sensor
Audi Q7 2007 ➤
51