Audi Q7 2007 Repair Manual page 64

Audi Q7 2007 ➤
Fuel Supply System - Edition 10.2018
– Disconnect fuel lines -1 and 2- from left locking flange by
pressing release button.
– Remove left locking flange with fuel filter housing and seal.
Installing
• Tightening specification. Refer to
⇒ "2.1 Overview - Fuel Delivery Unit and Fuel Gauge Sensor",
page 17 .
Install in reverse order of removal. Note the following:
Note
Replace seal.
– Connect electrical connector -arrow- on underside of left lock‐
ing flange.
– Install the new locking flange seal dry.
– Bring the left locking flange into the installation position.
• The tab -2- on left locking flange faces toward the arrow mark‐
ing and must lie between tabs -1 and 3- on fuel tank.
Version, Depending on the Country:
Note
If necessary, a country-specific installation of a Butyl adhesive
film -arrow- may be required. Pay attention to the related cam‐
paigns/actions.
Continuation for All Vehicles:
– Install locking flange cover.
– Insert the frame into the floor covering. Refer to the Parts Cat‐
alog and ⇒ Body Interior; Rep. Gr. 70 .
– Install the left seat cushion in the second row. Refer to ⇒ Body
Interior; Rep. Gr. 72 .
– Be sure to follow the procedure for connecting the battery and
afterwards. Refer to ⇒ Electrical Equipment; Rep. Gr. 27 .
60
Rep. Gr.20 - Fuel Supply
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.