Audi Q7 2007 Repair Manual page 10

Audi Q7 2007 ➤
Fuel Supply System - Edition 10.2018
11 - Rubber Gasket
12 - Cover
❑ Attached to the fuel filler door insert with an permanent fastener.
13 - Bolt
❑ 5 Nm
14 - Ground Connection
❑ For discharging electrostatic charge.
❑ Installed position / check requirements. Refer to
⇒ Fig. ""Installation Position of Ground (GND) Connection"" , page 7
❑ Ensure connector fits securely at metal ring of fuel filler tube.
15 - Bolt
❑ 9 Nm
16 - Overflow Hose
17 - Vent Line Bracket
❑ Secured to longitudinal member.
18 - Carrier Plate
19 - Bolt
❑ Tightening specification and sequence. Refer to
⇒ Fig. ""Fuel Tank, Tightening Specifications and Sequence"" , page 7
20 - Fuel Tank
❑ Removing and installing. Refer to
⇒ "1.3 Fuel Tank with Attachments, Removing and Installing", page 11
21 - Connectors
❑ For electric fuel pump and fuel level sensor.
❑ Remain on fuel tank when it is removed.
22 - Fuel Pump Control Module - J538-
❑ Illustrated: installed location through 10.06.
❑ Location from 11.2006. Refer to
⇒ Fig. "" Fuel Pump Control Module -J538- for Vehicles from 11.2006 - Tightening Specifications"" , page
7 .
❑ Removing and installing: vehicles through 10.06. Refer to
⇒ "2.4 Fuel Pump Control Module J538 , Through 10/2006, Removing and Installing", page 23
hicles from 11.06. Refer to
⇒ "2.5 Fuel Pump Control Module J538 , From 11/2006, Removing and Installing", page 23
23 - Bolt
❑ 3.5 Nm
6
Rep. Gr.20 - Fuel Supply
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
.
.
.
, ve‐
.