Unpacking The Ob7 Stand; Assembling The Ob7 Stand - productive robotics OB7 User Manual

GETTING STARTED WITH OB7

UNPACKING THE OB7 STAND

OB7 arrives in a single carton. If you've purchased a stand with your OB7 it will arrive in a small
wooden crate.
Before unpacking your OB7, you should prepare its mounting location.

ASSEMBLING THE OB7 STAND

The components of your OB7 robot stand are heavy. This is intentional to keep the
robot stable as it moves and carries objects. Always use two people to move or lift
heavy or awkward components.
Step 1:
Remove the 12 screws securing the top of the crate. Lift off the top of the crate.
Remove 12 screws.
Step 2:
Install the column. Cut the ties holding the column to the crate. Mount the column as shown
using the 8 M8 screws and the Allen wrench provided. Tighten the screws securely.
Cut the tie downs.
Lift off top of crate.
Install column with 8 M8 screws.
OB7 Collaborative Robot User Manual
OB7 Robot Stand In Crate
M6
Threaded
Hole
Rear-view of stand. Note that the
2 threaded holes in the column go
towards the back of stand.
Version 0.6
Getting Started With OB7 / 15