Fayat Group Dynapac SD2500C Operation & Maintenance Manual page 416

Depending on the specific use, the reflector plate (1) can be fitted in front of the buck-
A
et in the middle or to the side of the bucket on the left/right.
- Reflector plate in the middle: fixed with the corresponding clamping levers (2).
- Reflector plate on the side: dismantle reflector plate (1), mount additional retaining
rod (3) and support holder (4) to the required side.
- Fix retaining rod with the corresponding clamping levers (5).
- Mount the reflector plate to the retaining rod with the star handles (6).
- On reaching the required position, fix the pipe extension with the corresponding
clamping levers (7).
m When the reflector plate is fitted to the side, this increases the basic width of
the vehicle. Note the danger area!
The magnetic foil included in the scope of supply of the vehicle must be put on the
A
reflector plate (1) when in operation.
Operation with a feeder with slewing belt
NOTE
Preparations for paving
Separator fluid
Spray all surfaces coming into contact with
asphalt material with separator fluid.
m Do not use diesel fuel as it dissolves
the bitumen!
E 10 66
Caution! Possible damage to parts!
There is a risk of collision when using a feeder with slewing
belt! The bucket must be prepared as follows:
- Swivel the side flaps (8/9) and the front flap (10) down
(loosen corresponding clamping levers).