Fayat Group Dynapac SD2500C Operation & Maintenance Manual page 325

1.2 Preparation for transportation
- Close the hopper with switch (34)/(35).
- Engage both hopper transport safeguards.
- Lift the screed completely using switch (69), set the crossbeam lock (75).
- Turn the travel drive preselector (15) to zero.
- Activate set-up mode function (68).
- Fully extend the levelling cylinders with switch (61),(63)/(64).
To extend the levelling cylinders, levelling operating mode (126)/(130) must be
A
switched to "MANUAL" on the remote controls.
- Use switch (45)/(46) to adjust the screed to the basic width of the paver finisher.
m Lift the auger if necessary!
If the engine is started with the drive lever pivoted out, the travel drive is inhibited.
A
To start the travel drive, first the drive lever must be returned to the centre position.
D 41 17