Fayat Group Dynapac SD2500C Operation & Maintenance Manual page 380

Assembly of the short version is described in the following, as the longer variant is
A
achieved simply by adding further module elements.
MBS11.bmp
The distances between the sensors are ideally identical (X1 = X2).
The centre sensor is mounted in the usual individual sensor position so that, if nec-
A
essary, work can be carried out with just one sensor by switching over on the MOBA-
matic (e.g. at the start of paving, road junctions, etc...)
Depending on application, the mechanism can be mounted at the side next to the
A
screed or also above the screed. This is dependent on the paving width required in
each case.
The procedure for mounting the big ski is the same in both cases.
A
So that the big ski can be operated as parallel to the ground as possible during pav-
A
ing, it must be attached according to the subsequent paving conditions. To do this,
the screed should be lowered to the desired course thickness and the traction point
should be set appropriately.
m When mounting the two crossbeam brackets, it is vital to ensure that these do not
hamper the free movement of either the crossbeam or the screed construction! Clear-
ance must be guaranteed throughout the entire working range!
E 10 30