Fayat Group Dynapac SD2500C Operation & Maintenance Manual page 163

Item Designation
Conveyor
126
"MANUAL"
Conveyor
127
"AUTO"
Conveyor
128
"Reversing mode"
Brief description
Button with detent switch function and LED feedback:
- The conveying function of the corresponding half of
the conveyor is switched on continuously with full de-
livery capacity, without material control via the
limit switches.
- Switch OFF by pressing the button again
The function is shut off by pressing the EMERGENCY
A
STOP button or restarting the vehicle.
The main function switch locks the conveying function.
A
Button with detent switch function and LED feedback:
- The conveying function of the corresponding half of
the conveyor is switched on when the drive lever is
swivelled out and is continuously controlled via the
material limit switches.
- Switch OFF by pressing the button again
The function is shut off by pressing the EMERGENCY
A
STOP button or restarting the vehicle.
The main function switch (operating panel) locks the
A
conveying function.
Pushbutton function:
- The conveying direction of the corresponding half of
the conveyor can be reversed in order to slightly re-
verse e.g. paving material which may be present in
the material tunnel.
- Temporally limited reversal is carried out when the
button is pressed continuously.
The conveyor function must be switched to "AUTO" or
A
"MANUAL" for reversing mode.
In reversing mode, the automatic function is overridden
A
with reduced capacity.
D 11 69