Fayat Group Dynapac SD2500C Operation & Maintenance Manual page 371

3.4 Aligning the auger
- Loosen lock nuts (26).
Note the left-hand thread (L) and right-hand thread (R) mark on the brace!
A
- Extend or shorten the braces (17) by rotating both adjustment rods (21) until all
mounted material shafts align with the auger.
The adjustment rod (21) is equipped with a bore (27) on the left and right. A suitable
A
drift can be used to adjust the length of the adjustment rod here. The rotational direc-
tion for extending or shortening the adjustment rod is determined by the left-hand
thread (L) or right-hand thread (R).
A cord, which aligns with the screed or the rear wall of the vehicle, can be tensioned
A
e.g. to provide assistance during alignment!
- Extend the upper and lower adjustment rods until the material shafts are aligned
vertically.
- Retighten the lock nuts (26).
- Align the auger height in the same way by adjusting the vertical brace (23).
Check the horizontal alignment with a spirit level!
A
E 10 21