Table of Contents
Advertisement
Figure 439 SYSTEM > SNMP > SNMP Trap Group
The following table describes the labels in this screen.
Table 340 SYSTEM > SNMP > SNMP Trap Group
LABEL
Trap Destination IP
Apply
Cancel
79.16 Enable or Disable Sending of SNMP Traps on a Port
Click SYSTEM > SNMP > SNMP Trap Port to view the screen as shown. Use this screen to set whether a trap
received on the ports would be sent to the SNMP manager.
Chapter 79 Networked AV Mode
DESCRIPTION
Select one of your configured trap destination IP addresses. These are the IP addresses of the
SNMP managers. You must first configure a trap destination IP address in the SYSTEM > SNMP >
SNMP screen.
Use the rest of the screen to select which traps the Switch sends to that SNMP manager.
Select the individual SNMP traps that the Switch is to send to the SNMP station.
The traps are grouped by category. Selecting a category in the heading row automatically
selects all of the SNMP traps under that category. Clear the check boxes for individual traps
that you do not want the Switch to send to the SNMP station. Clearing a category's check
box automatically clears all of the category's trap check boxes (the Switch only sends traps
from selected categories).
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
XMG1930 Series User's Guide
598
Advertisement
Table of Contents
Troubleshooting
