What You Can Do; Service Access Control - ZyXEL Communications XMG1930-30 User Manual

A console port access control session and Telnet access control session cannot coexist when multi-login
is disabled. See the CLI Reference Guide for more information on disabling multi-login.
This section describes how to control access to the Switch.

79.37.1 What You Can Do

• Use the Service Access Control screen
use to access the Switch.
• Use the Remote Management screen
"trusted computers" from which an administrator may use a service to manage the Switch.

79.38 Service Access Control

Service Access Control allows you to decide what services you may use to access the Switch. You may
also change the default service port and configure "trusted computers" for each service in the Remote
Management screen (discussed earlier). Click SECURITY > Access Control > Service Access Control to
view the screen as shown.
Figure 465 SECURITY > Access Control > Service Access Control
The following table describes the fields in this screen.
Table 363 SECURITY > Access Control > Service Access Control
LABEL
Services
Active
Chapter 79 Networked AV Mode
(Section 79.38 on page
(Section 79.39 on page
DESCRIPTION
Services you may use to access the Switch are listed here.
Enable the switch button for the corresponding services that you want to allow to access the
Switch.
XMG1930 Series User's Guide
631
631) to decide what services you may
632) to specify a group of one or more