Table of Contents
Advertisement
Click Apply to save your changes back to the run-time memory.
9
10 Click the Save link in the upper right of the Web Configurator to save your configuration permanently.
6.3.3 Configure DHCPv4 Relay
Follow the steps below to enable DHCP relay on the Switch and allow the Switch to add relay agent
information (such as the VLAN ID) to DHCP requests.
Click NETWORKING > DHCP > DHCPv4 Relay > DHCP Smart Relay. Enable the Active switch button.
1
Enter the DHCP server's IP address (192.168.2.3 in this example) in the Remote DHCP Server 1 field.
2
Select default1 or default2 in the Option 82 Profile field.
3
Click Apply to save your changes back to the run-time memory.
4
Click the Save link in the upper right of the Web Configurator to save your configuration permanently.
5
The DHCP server can then assign a specific IP address based on the DHCP request.
6
Chapter 6 Tutorials
XMG1930 Series User's Guide
113
Advertisement
Table of Contents
Troubleshooting
