Enable Or Disable Sending Of Snmp Traps On A Port - ZyXEL Communications GS1350 Series User Manual

Fig ure 201
The following table describes the labels in this screen.
Table 133 Management > Access Control > SNMP > Trap Group
L ABEL
Trap Destination IP
Type
Options
Apply
Cancel
34.3.2 Ena b le o r Disa b le Se nding o f SNMP T ra ps o n a Po rt
From the
SNMP
whether a trap received on the ports would be sent to the SNMP manager.
Chapter 34 Access Control
Management > Access Control > SNMP > Trap Group
DESC RIPT IO N
Select one of your configured trap destination IP addresses. These are the IP addresses of the
SNMP managers. You must first configure a trap destination IP address in the
screen.
Use the rest of the screen to select which traps the Switch sends to that SNMP manager.
Select the categories of SNMP traps that the Switch is to send to the SNMP manager.
Select the individual SNMP traps that the Switch is to send to the SNMP station. See
on page 280 for individual trap descriptions.
The traps are grouped by category. Selecting a category automatically selects all of the
category's traps. Clear the check boxes for individual traps that you do not want the Switch
to send to the SNMP station. Clearing a category's check box automatically clears all of the
category's trap check boxes (the Switch only sends traps from selected categories).
Click to save your changes to the Switch's run-time memory. The Switch loses these
Apply
changes if it is turned off or loses power, so use the
save your changes to the non-volatile memory when you are done configuring.
Click to begin configuring this screen afresh.
C a nc e l
> screen, click
T ra p G ro up
GS1350 Series User's Guide
Sa ve
to view the screen as shown. Use this screen to set
Po rt
271
SNMP Se tting
SNMP Traps
link on the top navigation panel to