Attaching The Mounting Brackets To The Switch; Mounting The Switch On A Rack - ZyXEL Communications XMG1930-30 User Manual

2.4.3 Attaching the Mounting Brackets to the Switch

Position a mounting bracket on one side of the Switch, lining up the four screw holes on the bracket with
1
the screw holes on the side of the Switch.
Figure 10 Attaching the Mounting Brackets
Using a #2 Philips screwdriver, install the M3 flat head screws through the mounting bracket holes into
2
the Switch.
Repeat steps
3
You may now mount the Switch on a rack. Proceed to the next section.
4

2.4.4 Mounting the Switch on a Rack

Position a mounting bracket (that is already attached to the Switch) on one side of the rack, lining up
1
the two screw holes on the bracket with the screw holes on the side of the rack.
Figure 11 Mounting the Switch on a Rack
Using a #2 Philips screwdriver, install the M5 flat head screws through the mounting bracket holes into
2
Chapter 2 Hardware Installation and Connection
1 and 2 to install the second mounting bracket on the other side of the Switch.
XMG1930 Series User's Guide
43