ZyXEL Communications XMG1930-30 User Manual page 137

Table 40 MONITOR > Neighbor > Neighbor Details (continued)
LABEL DESCRIPTION
PoE Draw (W) For PoE models.
This shows the consumption that the neighboring device connected to this port draws
from the Switch. This allows you to plan and use within the power budget of the Switch.
PWR Cycle Click the Cycle button to turn OFF the power of the neighbor device and turn it back ON
again. A count down button (from 5 to 0) starts.
Note: The Switch must support power sourcing (PSE) or the network device is a
Reset Click this button to turn OFF the power of the neighbor device and turn it back ON again.
A count down button (from 5 to 0) starts.
Note: The Switch must support power sourcing (PSE) or the network device is a
Remote
System Name This shows the system name of the neighbor device.
Port Bridge This shows the neighboring device's MAC address or the port number connected to the
Switch.
Model This shows the model name of the neighbor device. This field will show "–" for devices that
do not support the ZON utility.
MAC This shows the MAC address of the neighbor device.
Firmware This shows the firmware version of the neighbor device. This field will show "–" for devices
that do not support the ZON utility.
Location This shows the geographic location of the neighbor device. This field will show "–" for
devices that do not support the ZON utility.
Desc. This shows the description of the neighbor device's port which is connected to the
Switch.
IPv4 This shows the IPv4 address of the neighbor device. The IPv4 address is a hyper link that
you can click to log into and manage the neighbor device through its Web Configurator.
IPv6 This shows the IPv6 address of the neighbor device. The IPv6 address is a hyper link that
you can click to log into and manage the neighbor device through its Web Configurator.
Restore Click this button to restore the neighbor device to its factory default settings. A warning
message "Are you sure you want to load factory default?" appears prompting you to
confirm the action. After confirming the action a count down button (from 5 to 0) starts.
Note:
•
•
•
Flush Click the Flush button on the port tab to remove information about neighbors learned on
a specific ports.
Flush All Click the Flush All button to remove information about neighbors learned on all ports.
Chapter 13 Neighbor
powered device (PD).
powered device (PD).
The Switch must support power sourcing (PSE) or the network device is a powered
device (PD).
If multiple neighbor devices use the same port, the Reset button is not available.
You can only reset Zyxel powered devices that support the ZON utility.
XMG1930 Series User's Guide
137